REMOVAL & INSTALLATION

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the front wheel speed sensors

  1. Raise and safely support the front of the vehicle.
    2.  
  2. Remove the tire and wheel. Remove the fender liner.
    3.  
  3. Disconnect the wheel speed sensor lead from the ABS harness. Remove any retaining bolts or clips holding the harness in place.
    4.  

Clips and retainers must be reinstalled in their exact original location. Take careful note of the position of each retainer and of the correct harness routing during removal.

  1. Remove the single bolt holding the speed sensor.
    2.  
  2. Carefully remove the sensor straight out of its mount. Do not subject the sensor to shock or vibration; protect the tip of the sensor at all times.
    3.  

To install:
  1. Fit the sensor into position. Make certain the sensor sits flush against the mounting surface; it must not be crooked.
    2.  
  2. Install the retaining bolt and tighten to 71 inch lbs. (8 Nm).
    3.  
  3. Route the sensor cable correctly and install the harness clips and retainers. Secure the harness clamp bolts to 49 inch lbs. (5 Nm). The cable must be in its original position and completely clear of moving components.
    4.  
  4. Connect the sensor cable to the ABS harness.
    5.  
  5. Install the wheel and tire. Attach and secure the fender liner.
    6.  
  6. Lower the vehicle to the ground.
    7.